by Lachlan
(brisbane, australia)
Im finding on my fill and cap runs.
the weld is sitting on the bottom too much?
ive tried to angle the rod different and amp different.
is the best option use stringers?
---------------------------------------------------
for a 6g, stringers are needed. but there is usually an option to weave just a tad.
sometimes a little slight weave motion slows down the upward travel just enough to allow you to re position your body as you progress.
try always aiming at the center of the pipe.
and use just enough amps to use a tight arc on the bottom to help the bead flatten out.